cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
670
Views
1
Helpful
3
Replies

Management tunnel no type client profile.

netcedec
Level 1
Level 1

Hello. Cisco ASAv 9.19, ASDM 7.19. When configuring the management tunnel cisco asa does not allow you to create a client profile with the management type.
No type AnyConnect Management VPN profile.

netcedec_0-1697723315822.png

 

 

 

3 Replies 3

Pavan Gundu
Cisco Employee
Cisco Employee

PavanGundu_0-1699123245190.png

I see it on my side though.


labasa# sh ver

Cisco Adaptive Security Appliance Software Version 9.19(1)22
SSP Operating System Version 2.13(0.2004)
Device Manager Version 7.19(1)95

 

asavdp# show version

Cisco Adaptive Security Appliance Software Version 9.19(1)
SSP Operating System Version 2.13(0.198)
Device Manager Version 7.19(1)

Compiled on Mon 28-Nov-22 15:40 GMT by builders
System image file is "boot:/asa9191-smp-k8.bin"
Config file at boot was "startup-config"

asavdp up 25 days 19 hours
Start-up time 52 secs

Hardware: ASAv, 4096 MB RAM, CPU Xeon 4100/6100/8100 series 2300 MHz, 1 CPU (2 cores)
Internal ATA Compact Flash, 1024MB
Slot 1: ATA Compact Flash, 1024MB
BIOS Flash Firmware Hub @ 0x0, 0KB

srpoda
Cisco Employee
Cisco Employee

Kindly verify if the ASA has any AnyConnect Linux images configured in the webvpn section. AnyConnect VPN Management is not supported by Linux.

You can check if any Linux anyconnect images on ASA in below path

ASDM --> Configuration --> Remote Access VPN --> Network (Client) Access --> Anyconnect Client Software.

Please try to remove linux anyconnect image from ASA and relaunch ASDM

https://www.cisco.com/c/en/us/support/docs/security/adaptive-security-appliance-asa-software/215442-configure-anyconnect-management-vpn-tunn.html