04-11-2009 12:59 AM
hi all,
I configured site-site vpn b\w ASA 5510 & ASA 5505.Its works fine,I can able to ping the host from both sides.
But I have the following problem
1.I can access the shared folder from the peer host using its IP address.but I cannot able to access it with computer name for ex:\\akl13
I think it may be the problem with NetBios/WINS service through VPN
My question is how can I enable NETBIOS over VPN ( site-site)
I am attaching the configuration
ASA Version 7.0(8)
!
hostname ciscoasa
domain-name default.domain.invalid
enable password 2KFQnbNIdI.2KYOU encrypted
passwd 2KFQnbNIdI.2KYOU encrypted
names
dns-guard
!
interface Ethernet0/0
nameif outside
security-level 0
ip address 192.168.2.6 255.255.255.0
!
interface Ethernet0/1
nameif inside
security-level 100
ip address 172.16.1.1 255.255.255.0
!
interface Ethernet0/2
shutdown
no nameif
no security-level
no ip address
!
interface Ethernet0/3
shutdown
no nameif
no security-level
no ip address
!
interface Management0/0
nameif management
security-level 100
ip address 192.168.1.1 255.255.255.0
management-only
!
ftp mode passive
access-list inside_pnat_outbound extended permit ip 172.16.1.0 255.255.255.0 192
.168.4.0 255.255.255.0
access-list outside_cryptomap_20 extended permit ip 192.168.3.0 255.255.255.0 19
2.168.4.0 255.255.255.0
pager lines 24
logging asdm informational
mtu management 1500
mtu outside 1500
mtu inside 1500
no failover
asdm image disk0:/asdm-508.bin
no asdm history enable
arp timeout 14400
static (inside,outside) 192.168.3.0 access-list inside_pnat_outbound
route outside 0.0.0.0 0.0.0.0 192.168.2.6 1
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00
timeout mgcp-pat 0:05:00 sip 0:30:00 sip_media 0:02:00
timeout uauth 0:05:00 absolute
username dileep password STkzljfDxlzWJX9D encrypted privilege 15
http server enable
http 192.168.1.0 255.255.255.0 management
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart
crypto ipsec transform-set ESP-3DES-SHA esp-3des esp-sha-hmac
crypto ipsec security-association lifetime seconds 28800
crypto ipsec security-association lifetime kilobytes 4608000
crypto map outside_map 20 match address outside_cryptomap_20
crypto map outside_map 20 set peer 192.168.2.7
crypto map outside_map 20 set transform-set ESP-3DES-SHA
crypto map outside_map 20 set security-association lifetime seconds 28800
crypto map outside_map 20 set security-association lifetime kilobytes 4608000
crypto map outside_map interface outside
isakmp enable outside
isakmp policy 10 authentication pre-share
isakmp policy 10 encryption 3des
isakmp policy 10 hash sha
isakmp policy 10 group 2
isakmp policy 10 lifetime 86400
tunnel-group 192.168.2.7 type ipsec-l2l
tunnel-group 192.168.2.7 ipsec-attributes
pre-shared-key *
telnet timeout 5
ssh timeout 5
console timeout 0
dhcpd address 192.168.1.2-192.168.1.254 management
dhcpd lease 3600
dhcpd ping_timeout 50
dhcpd enable management
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map global_policy
class inspection_default
inspect dns maximum-length 512
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
!
service-policy global_policy global
Expecting your valuable reply
Solved! Go to Solution.
04-14-2009 05:45 AM
In order to reach a workstation through WINS name resolution there has to be a WINS server shared on both networks workgroups if you will. NetBIOS over TCP is a feature that is enabled on the actual network settings on the PC and not on the firewall.
04-13-2009 07:10 AM
Hi, first of all you need to be aware that some netbios broadcast traffic will not pass through a vpn, so you would need to switch to NetBIOS over TCP, once you have done this make sure both endpoints share the same WINS server.
04-14-2009 03:55 AM
Dear imartino,
thanks for the information,but the issue is that host on both side of the tunnel are in different workgroup.there is no WINS server.
one more thing i have to know is that how can I enable NetBios over TCP through CLI.
Expecting your reply
dileep
04-14-2009 05:45 AM
In order to reach a workstation through WINS name resolution there has to be a WINS server shared on both networks workgroups if you will. NetBIOS over TCP is a feature that is enabled on the actual network settings on the PC and not on the firewall.
04-14-2009 09:38 AM
thanks a lot for this valuable information
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide