12-18-2018 01:36 AM
Good morning all.
I am hoping this message finds all well.
I am looking for some assistance in troubleshooting an issue that I have been struggling with.
We are running a Cisco ASA 5515x and we use cisco anyconnect vpn for staff to connect to servers inside the office when they are remote.
We recently moved offices and installed new Internet lines and this was all configured accordingly on the ASA.
The new subnets were also added to the vpn ACL.
The problem we are facing however, is that the vpn client establishes a connection, and the relevant routes are in fact added to the client machine's routing table.
However, we are unable to access any of the servers on the network.
When testing from the ASA itself , it can reach the servers, but not working via vpn.
any suggestions would be well appreciated.
Regards
Solved! Go to Solution.
12-18-2018 11:00 AM
Add a nat exemption for the interesting traffic.What ever you have for your source and destination acl use that for the source and destination nat.Should look something like this nat (LAN,WAN) source static LOCAL LOCAL destination static REMOTE REMOTE.
Here is a link to a community post about how to do nat via cli or asdm.If you are using FTD let me know and I can assist you.
12-18-2018 02:16 AM
12-18-2018 11:00 AM
Add a nat exemption for the interesting traffic.What ever you have for your source and destination acl use that for the source and destination nat.Should look something like this nat (LAN,WAN) source static LOCAL LOCAL destination static REMOTE REMOTE.
Here is a link to a community post about how to do nat via cli or asdm.If you are using FTD let me know and I can assist you.
12-20-2018 01:05 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide