cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
291
Views
0
Helpful
2
Replies

No Local Access - IPSEC Remote Access

cplatt01
Level 1
Level 1

I have a strnge issue where several users can connect to the ASA 5520 (8.0(4)) VPN, and get an IP address. But they cannot browse any network shares, ping internal sites, etc. However, when they remove the Linksys router from the mix, they can connect. I have NAT-T enabled, and there are several other users that can connect through their Linsys router and browse anything on the local LAN.

Has anyone experienced this type of behavior? There is just no consistency!

Thanks in advance!

2 Replies 2

Marwan ALshawi
VIP Alumni
VIP Alumni

do u have NAT exmption (nat 0) configured correctly on ur ASA ?

traffic from internal lan to remote access users pool should be exmpted from nat with nat 0

singhsaju
Level 4
Level 4

Can you post the config for analysis?

HTH

Saju

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: