05-03-2006 10:20 AM
Hi,
I have a cisco 2610XM that is used as terminal server. I would like to create a remote access through the PSTN network using the WAN Interface Card - One Port Analog Modem. From the router side the interface is RJ-11 and from PBX side the interface is RJ-45. What is the pinout that I must use?
Regards
05-03-2006 11:31 AM
PSTN generally uses the two pins in the center of the connector. (4,5 on RJ45, 2,3 on RJ11.
Goodluck,
Leo
05-04-2006 09:46 PM
I use the NM-16AM-V92 which is a 16 port version of the one port WIC.
You use the centre two pins on the WIC (RJ45).
You would normally use only the centre pins on the RJ-11, but you would need to check the wiring to be sure.
05-11-2006 03:47 AM
i think that you need to know the pinout from pbx side,
the pinout of wic-1am is the two central pin.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: