PIX 501 and Manual IPSEC

[fzink]

Hi,

I would like to configure Manual IPSEC on my PIX501, unfortunately each time I configure it I have the following error:

ipsec-manual mode is not allowed in this PIX

O don't know it is just a problem of licence or if it is a limitation of the chassis. If you have any info please let me know.

Thank you.

[scoclayton]

Manual IPSec is not supported on the 501 platform due to the restriction on the ISAKMP peers. It is documented here:

"Note Manual configuration of SAs is not supported on the PIX 501."

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/c.htm#wp1034654

and "Note Manual configuration of SAs is not supported on the PIX 501 because of the restriction in the number of ISAKMP peers allowed on that platform."

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/config/ipsecint.htm#wp1045493

Scott

[fzink]

Thank you very much.

Frédéric