pix 501 pppoe

[erodrig]

Hi, i am going to configure a pix 501 as pppoe client, and i wnat to the hosts in the inside interface reach internet, the pix will take an ip address asigned by pppoe.

do i need to configure PAT? how can i do to users go internet with the ip address that pppoe will assign to the outside interface?

thanks

[thisisshanky]

## This will take care of PAT

global (outside) 1 interface

nat (inside) 1 0.0.0.0 0.0.0.0 0 0

## PPPOE config on the PIX

vpdn group Test request dialout pppoe

vpdn group Test localname

vpdn group Test ppp authentication pap

vpdn username password *********

## The command below will set the default route on pix to the one obtained via PPPOE

ip address outside pppoe setroute