09-11-2007 08:14 AM - edited 02-21-2020 03:15 PM
I think I already know the answer is no, however I would like this to be confirmed.
We have multiple IPSEC VPN Clients accessing a cisco pix 501. The pix allocates them an address on the main site lan and the clients can all communicate fine with devices on that LAN.
The question is can a VPN Client route traffic to another VPN Client on the same CISCO PIX.
I.e,
Client A gets IP address 10.0.1.20
Client B gets IP Address 10.0.1.21
is it possible to route traffic between 10.0.1.20 and 10.0.1.21?
Thanks
09-11-2007 02:12 PM
so basically the traffic comes in the outside interface, and is suppose to leave the outside interface, correct?
VPN Hairpin:
same-security-traffic permit intra-interface
Which is only available on PIX/ASA 7.x and higher. and your 501 cannot go any higher than 6.x.
09-12-2007 01:42 AM
Thanks for the prompt response, would a Cisco Pix 515 support this with the correct firmware?
Do you know if all new PIX 515 and above come with 7.x firmware or does this have to be added?
Regards Richard
09-12-2007 04:15 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: