02-19-2002 06:42 AM - edited 02-21-2020 11:36 AM
I have two PIX 525 with DMZ's. I have a VPN tunnel created between the two. The users on the inside network at site A have to get to a server on the DMZ at site B. I currently have site A accessing the DMZ server at site B by its Internet address.
Is there a way to allow site A users to access site B DMZ server via the tunnel?
02-26-2002 02:11 PM
Not with PIXs alone. Youll need and inside router at both sites to route between the two networks across the tunnel.
02-27-2002 04:52 AM
Hi, yes that configuration is already in place. And the routing is setup. We use the Tunnel for inside network to inside network communications.
My question is, though, I cannot get to their DMZ.
There are routes from my LAN (lan A) to the other LAN (lan B) to the PIX's. This works. However, I cannot get to the DMZ interface on firewall in LAN B
How do i configure my pix/routers to get to the DMZ on firewall B?
02-27-2002 01:11 PM
Hi there,
From what you describe, it sounds like you have a workable topology. Probably just need some config assistance from the TAC.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide