cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1900
Views
0
Helpful
16
Replies

Ports on ASA

laurabolda
Level 1
Level 1

We have 4 ports on the ASA 5510.  Port 0 is Outside, Port 1 is inside, Ports 2 and 3 are not in use.

1.  If I configure ports 2 and 3 as Inside interfaces, using the same subnet as port 1 (192.168.100.0), do I connect ports 1, 2, and 3 using cross over cables?  Is there a special configuration that I need to configure so that there is communication between the servers in these ports? 

2.  If I configure ports 2 and 3 as Inside interfaces, would you use the same subnet or different subnets from port 1?

3.  What do people normally use ports 2 and 3?


Let me know if you want to see the current config or need additional information.  Thanks.

16 Replies 16

1) The static NAT statement should be as follows:

static (Dmz,outside) 66.102.7.89 192.168.102.3 netmask  255.255.255.255

2) Split tunnel ACL used to be extended ACL in PIX version 6.3 and below, however, since PIX/ASA version 7.0 and above, you would need to use standard ACL to configure split tunnel. Here is the URL for your reference:

http://www.cisco.com/en/US/docs/security/asa/asa80/command/reference/s8.html#wp1404816

Hope that answers your questions.

Halijenn,

Thank you very much for your prompt response and information.  Your suggestions work!!!.  You are great!!!  Have a nice day.

Laura