cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
541
Views
4
Helpful
2
Replies

PRI to BRI connection between h.o and remote branch

Dear all,

in my H.O i have a 2801 with VWIC2-1MFT E1/T1 and i have an E1 leased connection which is 2.048Mb, and at the branch side

i have 1841 and ISDN BRI card and my ISDN BRI connection is ready at remote branch

i need to connect between these 2 offices, can anybody give a sample configuration, i will be connecting 10 remote offices in future.

i will rate all the posts.

regards

BInoy

2 REPLIES 2

JamesLuther
Participant
Participant

Hi,

Please find an attached example config for a central site where

10.0.0.0/24 is the central site

10.0.1.0/24 is site 1

10.0.2.0/24 is site 2

The transits between the sites are 10.99.99.x/30

The ISDN config is for a UK E1 PRI.

Not sure if this exactly what you need but I hope it helps

Regards

hi james,

thank you for your reply.

i have couple of doubts.as i have explained in my first post, i have a leased line which is E1 and for sure i can channelize it. suppose site 1 using BRI so the site 1 router need to dial into my H.Q correct me if i'm wrong?

as it is a leased line at H.Q i will not be getting seperate no's for PRI channels. i'm really confused it will be great if you can provie your views.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: