09-01-2012 10:49 AM
Hi guys,
I got an access server setup and got a couple issues.
First off is that after I establish a session to another router or switch I cannot get back to the access server!
I do "ctrl shift 6 x" and many variations of that as suggested by forums on the internet but I just cannot seem to get back to the access server which is very annoying.
Something which I noticed with the 2511 also is that it seems to be very slow. e.g. just to erase startup config it took a good 5-7 seconds and was unresponsive while doing so?
Should that be the case?
Many thanks,
Josh
09-02-2012 02:16 AM
For the first problem, check, line configuration.
And yes an old 2511 is as slow as you described, or possibly even slower
09-06-2012 06:13 AM
Hi Paolo,
Thanks for that, I realize now how slow this thing is with certian things..but an absolute god send to use an access server
And for those looking about not being able to send a "break" command to their router/switch I changed my default break command to "Ctrl + Pause/Break (key)"
instead of: ctrl shift 6 x.
Works like a charm now.
I changed this by issuing the following command under conf t:
line 1 16
escape-character BREAK
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide