we would like to start using our ISE for Remote VPN access.
We have run a proof of concept with the ISE & IPEP with a Cisco ASA5505. We got the authentication working however posturing of the client did not work.
That was a few months ago and so I was wondering whether any design document is available specifically around Using the Cisco ISE for Authenticating & Posturing Remote Access VPN clients.
I understand that version 9 of the ASA code is supposed to eliminate the need for Inline Posture, does anyone know whether this will also allow posturing too?
We do intend to by Cisco ASR's aswell, but I am sceptical of this as i do not know how many VPN licenses you get out of the box. The ASA's we have allow up to 5000 IPSec VPNs without having to purchase any licensing. What I do not want to do is to switch to SSL VPNs as this again will increase cost.
I know ISR's are support NADs but what about ASRs? There is no mention.
The Cisco Secure Firewall and SecureX teams are looking for feedback from active Secure Firewall users who may or may not have already activated SecureX. Your responses will help us improve the Firepower experience in SecureX. Th...
Related documentsCisco ISE (Identity Services Engine) IPv6 features by release2.6ISE ManagementNetwork Time Protocol SupportDomain Name System SupportExternal RepositoriesAudit Logs and ReportsSimple Network Management ProtocolAccess Control Lists And Dyn...
Site to Site IPSec VPN with Dynamic IP Endpoint is typically used when we have a branch sites which obtains a dynamic public IP from the Internet ISP. For example an ADSL connection.One important note is that Site-to-Site VPN with Dynamic remote routers P...
On R1, configure a key ring that defines the peer R3:Address: 220.127.116.11Local and remote pre-shared key: cisco R1(config)#crypto ikev2 keyring KRR1(config-ikev2-keyring)# peer R3R1(config-ikev2-keyring-peer)# address 18.104.22.168R1(config-ikev2-keyring-pee...