Routing al external trafic thru hub.

[Luvi45]

I was given a point to point MPLS connection to my remote office. I setup a site-to site VPN, which partially worked.

How can I force all traffic from the remote to go thru the main office router.

They both are 2800.

Thank you

[carenas123]

You need to disable the split-tunneling at the remote router. Without split-tunnelling, all the traffic from the remote site will go through the VPN tunnel to the main office router. If the traffic is for the remote LAN, it will be forwarded to the LAN and if the traffic is for the Internet, it will be sent to the Internet.

This might configuration on both of your routers.

I presume that routing is configured correctly

[atif.awan]

We need to take a look at the configuration. When you say it worked partially what do you mean ... what part did work and what part did not work?

[Luvi45]

Thank you.

I forgot to add the ip nat inside in the GRE Tunnel interface; for some reason I was under the impression that it was not supported.

Once I got that advice from Juan Perez (Cisco TAC), it worked fine.