cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
456
Views
0
Helpful
7
Replies

RP2 Land the telnet in Linux and dont ping outside

radwango1
Level 1
Level 1

Hello,

I have 2 ASR 1000-RP2, one of them let me Land on Linux if I make Telnet session and let me not land on IOS through Telnet untill I configure transport-map, Also this RP2 make no PING through VRF Interface instead of Static ROuting Configuration, the other RP2 work normally without the need to make any Transport-MAP and the ping to outside works usually without the need for any configuration, can someone help me?

7 Replies 7

Hello,

can you post the configs of both devices ?

both devices are without configuration but one of the card need no speical configuration to allow telnet, the other one need persistant Telent untill be reachable through telnet, otherwise it will let the telnet user land in the linux mode.

Hello,

I checked for bugs, none found.

are both cards running on the same IOS XE  and ROMMON ?

IOS XE yes the same, ROMMON I m not sure, have I to check?, do u think could be a cause behind that, or I have to go in another direction.

Honestly I can't think of anything else, it might at least be worth trying...

It has already new version of rommon

is this rp2 require ESP40 in order to work ? or i can test it using just a chassis and rp2? can anyone give me an Answer