RVS4000 to WRVS4400N VPN Can't see other computers
I have a VPN tunnel up between these two routers and can't see any of the other computors accross the tunnel. I have local secure group ip set at 192.168.1.0 (rvs) and remote secure group at ip 192.168.2.0 (wrvs), subnet is 255.255.555.0. With this I also have a 100% packet loss when I ping from the router diagnostics of the rvs4000 to the wrvs4400n. I can ping all ip addresses from the command line of the computers on both sides of the tunnel. I can also ping all ip addresses from inside the diagnostics on the wrvs4400N with no problem. I downloaded the VPN setup wizard v1.2 for the rvs4000 series routers and cannot remotely or locally access the rvs4000 through this utility. I can access both router utilities locally or through
IE9 & the tunnel I created without using the utility. Netbios was checked and saved on both routers after the tunnel was created. I did a firmware upgrade on both routers rvs4000 v126.96.36.199, wrvs4400n v1.1.13. Remote access is enabled on both routers. Any help would be appreciated.
Radius server configuration for 802.1X
Server radius test1
Address ipv4 10.1.1.1
Server radius test2
Address ipv4 10.1.1.2
aaa group server radius TEST-gr
server name test1
server name test2
Umbrella’s cloud-delivered firewall (CDFW) is a cool features that provides Firewall Services in the Cisco Umbrella Cloud without the need to deploy on-premises firewall devices and visibility and control for internet traffic across all branch offices. To...
SymptomsDownloadable ACL (dACL) does not take effect on the IOS-XE Network Access DevicesDiagnosisCreating redirection ACL on the IOS-XE device failed to redirect the specified traffic for captive portal redirectionSolutionEnable device tracking, Below is...
Multiple Cisco Security Technologies in a single book : ASA Firepower, WSA, Umbrella, ISE and VPN with 100 percent 100 practical scenarios with 70 Labs to cover important topics of the Cisco SCOR Exam. The best part is ISE with interesting scenarios wi...