cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2152
Views
0
Helpful
1
Replies

Show vpn-sessiondb is showing 2 active sessions by peer

oscar.montoya1
Level 1
Level 1

Hello,

 

I have multiple L2L vpn sessions in my FPR2110 with FMC, but when I apply de command "show vpn-sessiondb l2l filter ip address x.x.x.x" I am seeing two active sessions for the same peer and the traffic RX/TX increments in both sessions, is it normal?

 

When I applied a logoff in the vpn I see both session down, then the tunnel is up again but now I only see one session active.

 

How can I resolve this?

 

Thanks!

1 Accepted Solution

Accepted Solutions

Issue the command as "show vpn-sessiondb detail l2l filter ip address x.x.x.x". There you should see that these two tunnel refer to different traffic. You can also see that at the crypto-definition of your VPN-config.

View solution in original post

1 Reply 1

Issue the command as "show vpn-sessiondb detail l2l filter ip address x.x.x.x". There you should see that these two tunnel refer to different traffic. You can also see that at the crypto-definition of your VPN-config.