site to site router 877

[george]

i wanna ask u something easy to you and i need your help in several things

i have two router cisco 877 and i want to make a VPN  between them

first of all could you with a few words explain to me what can i do in general

and i have another quest plz

i  have a 2MB of internet speed, can i take like 512KB from the speed for  the VPN so this router can support that if so could you tell me the  command plz

[Jennifer Halim]

hey George...

Just about to reply on your earlier post, but saw this post, so i'll just reply on this new one

Here  is a sample configuration between 2 IOS router for LAN-to-LAN VPN  tunnel (assuming that both routers will have static IP Address for its  outside interface):

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a0080194650.shtml

If  one of the router has dynamic ip address assigned to its outside  interface, then here is the configuration guide (dynamic to static IPSec  LAN-to-LAN tunnel):

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a00801dddbb.shtml

[Jennifer Halim]

BTW, here is a post on QoS for your reference:

https://supportforums.cisco.com/message/3116856

I am not sure whether 877 supports QoS though. You might need to check if it supports QoS.

[george]

thank you a lot Jenny

[Jennifer Halim]

Cheers, pls kindly mark it as answered if you have no further questions so others can learn from the post. Thank you.

[george]

Cheers man

i m reading the documents

[george]

sorry Jenny but i could n't find any solution about it

could you advice me to ask someone quickly cause i have to resolve it tonight

thanks in advance

[Jennifer Halim]

Sorry, but what exactly is the issue, and where is it failing? What has been configured?

[george]

there's not til now any failure cause im going to implement it

the point is how can limit the bandwidth between them like i want to give them like 1MB from 4MB

[Jennifer Halim]

Have you checked out the post I advised earlier?

Here it is again:

https://supportforums.cisco.com/message/3116856#3116856

In your case, since you would like to apply 1 Mb out of 4 Mb, then the bandwidth percentage for IPSec would be 25% and the rest (class default) would be 50%.