I am looking to configure a site to site VPN connection between two ASA firewalls.
On one of the firewalls, I have the interface IP as 18.104.22.168, with subnet mask 255.255.255.248, this is the interface i intend to use for the VPN connection.
My question is can I use the IP 22.214.171.124 as the peer IP in the VPN configuration since this IP "126.96.36.199" falls under the same subnet of my current interface IP or do I have to use the interface IP; 188.8.131.52, since it's configured on the firewall as the interface IP address.
On the ASA you enable ikev1/ikev2 on an interface, once enabled you can only establish a VPN tunnel to the IP address of the interface ikev1/ikev2 is enabled on, not another IP address in that network.
I am involved in rolling out about 40 wifi networks using cisco 3602/2802 aps and cisco 5508 ISE. Our network offers a 2 step authentication with user and machine certificates as well as users needing to be in correct AD groups. The problem we have i...
ASA Site-to-Site VPN using IKEV1 Configuration Example
Configure a Site-to-Site IPSec IKEv1 Tunnel Between an ASA and a Cisco IOS Router
Site-to-Site IKEv2 Tunnel between ASA and Router Configuration Examples
Site-to-Site VPN Tunnel wit...
Dear Community, So, according to the Cisco ISE Release 2.7 Administrator Guide, it should be possible to use a remote lock/wipe on MDM-devices that connect through ISE on the network( see the screenshot in the attachment).The problem is that th...
Hi, We currently have 2 Cisco 5525X ASA's in active/standby state. We have 750 concurrent Anyconnect licenses with the below licenses:AC-PLSM-5YR-500-S & AC-PLSM-5YR-250-S. (These are expiring soon) I have asked to get these renewed by our l...
Hi Everyone, Does anyone know if it is possible create a NAT for Cisco Anyconnect to a different IP so that the user doesn't have to use the External IP? We want to use a different dns name and assign to a different set group of users. Thank you...