Hi all have S2S VPN connection and i am performing Nating
by using access list
Extended IP access list 100 10 permit ip 10.0.0.0 0.0.255.255 126.96.36.199 0.0.0.255
And Overloaded to LoopBack1
interface Loopback1 ip address 188.8.131.52 255.255.255.255end
ip-10-0-0-156#show run | inc ip nat ip nat outside ip nat insideip nat inside source list 100 interface Loopback1 overload
interface GigabitEthernet1 ip address dhcp ip nat inside negotiation autoend
interface Tunnel1 ip address 169.254.249.50 255.255.255.255 ip nat outside ip tcp adjust-mss 1387 tunnel source GigabitEthernet1 tunnel mode ipsec ipv4 tunnel destination 184.108.40.206 tunnel protection ipsec profile ipsec-vpn-Vodafone-mgmtAWS-0 ip virtual-reassemblyend
Nating is working properly but traffic after Nating to (220.127.116.11) is not entering to the tunnel interface and interface will go down
please advise and help ASAP
Let me see If I get this correctly, so what you want is that the 10.0.0.0/16 traffic when it's going to 145.230.12/24 gets natted to 18.104.22.168??
Before the traffic tries to leave, can you see the tunnel is up?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: