cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
106
Views
0
Helpful
2
Replies

Site to Site VPN

sulochana123
Beginner
Beginner

I have VPN connection .

172.16.24.x/24-----60.34.12.208=========202.22.29.80-----10.86.249.x/24

(local side)                                       (remote side)


I have to allow icmp(ping) from 10.86.249.x/24 to host 172.16.24.48.  Please help me to configure this.

Thanks,
Sulochana

2 Replies 2

Boris Uskov
Enthusiast
Enthusiast

Hello, Sulochana.

Please, provide some more information in order the Community can help you.

What devices are used to build VPN-Tunnel from both sites? Cisco Routers, Cisco ASAs or something else?

Can you configure devices on both sites or you have access only to one site of VPN-tunnel?

 

And the best way to give us more information is to post the configurations of devices, while cleaning out all sensitive information (domain names, user names, passwords, maybe IP-addresses).

Hi,

 

In addition to above suggestion, you can also check any icmp block/firewall enabled on both end hosts. Also check antivirus settings as well and make sure local ping works. As long as the tunnel is up, encrypted traffic flow should pass unless you have ACL in place for VPN traffic.

hth

MS

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers