08-21-2018 10:01 PM - edited 02-21-2020 09:26 PM
Hi
I am seeking for the reason why the state from one of two DMVPN tunnels of SPOKE is stuck in IKE, however the relevant HUB shows the state regarding the SPOKE as UP.
The output from show commands is as below;
SPOKE1#show dmvpn
Legend: Attrb --> S - Static, D - Dynamic, I - Incomplete
N - NATed, L - Local, X - No Socket
# Ent --> Number of NHRP entries with same NBMA peer
NHS Status: E --> Expecting Replies, R --> Responding
UpDn Time --> Up or Down Time for a Tunnel
==========================================================================
Interface: Tunnel50, IPv4 NHRP Details <-- DMVPN tunnel to HUB2 through PPPoE network
Type:Spoke, NHRP Peers:1,
# Ent Peer NBMA Addr Peer Tunnel Add State UpDn Tm Attrb
----- --------------- --------------- ----- -------- -----
1 10.220.251.145 10.220.143.1 IKE 05:14:57 S
Interface: Tunnel60, IPv4 NHRP Details <-- DMVPN tunnel through MPLS network
Type:Spoke, NHRP Peers:1,
# Ent Peer NBMA Addr Peer Tunnel Add State UpDn Tm Attrb
----- --------------- --------------- ----- -------- -----
1 10.220.147.1 10.220.148.1 UP 4d18h S
HUB2#show dmvpn
Legend: Attrb --> S - Static, D - Dynamic, I - Incomplete
N - NATed, L - Local, X - No Socket
# Ent --> Number of NHRP entries with same NBMA peer
NHS Status: E --> Expecting Replies, R --> Responding
UpDn Time --> Up or Down Time for a Tunnel
==========================================================================
Interface: Tunnel100, IPv4 NHRP Details
Type:Hub, NHRP Peers:13,
# Ent Peer NBMA Addr Peer Tunnel Add State UpDn Tm Attrb
----- --------------- --------------- ----- -------- -----
1 10.220.251.170 10.220.143.9 UP 05:18:20 D
08-22-2018 06:01 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide