Upgrade ASA 5505 to 845 get "Not enough space on device" after selecting "Upload configuration"

[johncarl1]

Using ASDM 7.0(2) to upgrade ASA 8.4(2) to 8.45.  Navigate "Tools-Upgrade software from local computer"  and select "Upload Image" from the following:

It returns the following:

How can I get around this?

Thanks.

[Javier Portuguez]

Hi John,

Please check this out:

Standard Memory and Memory Requirements  for the Cisco ASA Series

ASA Model	Internal Flash Memory (Default Shipping)	DRAM (Default Shipping)
		Before Feb. 2010	After Feb. 2010 (Required for 8.3 and Higher)
5505	128 MB	256 MB	512 MB

So, you need to make sure your ASA meets this requirement.

On the other hand, the error above means that the Flash memory is full.

Check this out:

To run Version 8.3 and later in a production environment, you might need to upgrade the memory on the Cisco ASA 5505, 5510, 5520, or 5540. (For more information about memory, see the Cisco ASA Compatibility.)

Important: To upgrade from 7.x or from 8.0.x to 8.4, you must follow: 7.x ---> 8.2 ---> 8.3 ----> 8.4. Otherwise you may encounter configuration issues.

HTH.

Please rate any helpful posts.