Hi Sachin,
Once on the console (with the cable unplugged) do this:
1) Configuration
2) Administration
3) Monitoring
4) Save changes to Config file
5) Help Information
6) Exit
Standard Forwar~: Main -> 1
1) Interface Configuration
2) System Management
3) User Management
4) Policy Management
5) Tunneling and Security
6) Back
Standard Forwar~: Config -> 2
1) Servers (Authentication, Authorization, Accounting, DNS, DHCP, etc.)
2) Address Management
3) IP Routing (static routes, OSPF, etc.)
4) Management Protocols (Telnet, TFTP, FTP, etc.)
5) Event Configuration
6) General Config (system name, time, etc.)
7) Client Update
8) Load Balancing Configuration
9) Back
Standard Forwar~: System -> 5
1) General
2) FTP Backup
3) Classes
4) Trap Destinations
5) Syslog Servers
6) SMTP Servers
7) E-mail Recipients
8) Back
Standard Forwar~: Event -> 1
1) Enable/Disable Save Log on Wrap
2) Format for Saving Log
3) Enable/Disable FTP Save Log on Wrap
4) Set E-mail source address
5) Set Event Forwarding
6) Format for Syslog
7) Back
Standard Forwar~: Event -> 5
1) Which Events get Logged
2) Which Events go to the Console
3) Which Events go to the Syslog
4) Which Events go to E-mail
5) Which Events go to SNMP Trap
6) Set General Event List
7) Back
Standard Forwar~: Event -> 2
Which Events are Sent
0 : No Events
1 - 13 : Maximum Event Severity Level (see table below)
99 : Use General Event List
The following is a description of the Event Severity Levels
Severities 1 - 3 are Warning : 1 - Fault 2 - Warning1 3 - Warning2
Severities 4 - 6 are Info : 4 - Info1 5 - Info2 6 - Info3
Severities 7 - 9 are Debug : 7 - Debug1 8 - Debug2 9 - Debug3
Severities 10, 11 are Decodes: 10 - Hdecode 11 - Ldecode
Severities 12, 13 are Dumps : 12 - HdrDump 13 - PktDump
The maximum allowable severity for this menu item is 5
> Which Events go to the Console
Standard Forwar~: Event -> [ 1 ] 1
Then connect the 3K to the network. If you try to open the console, do you see the same issue?
Thanks.
Portu.
Please rate any posts you find useful.
