I have a user using windiows 7 64 bit. I tried vpnclient-winx64-msi-5.0.07.0290-k9.exe and vpnclient-winx64-msi-5.0.07.0440-k9.exe. Installation is fine. Connecting is fine. But no traffic goes through.
The remote end cisco is 1811 VPN Server split tunnel. User get authenticated by Radius server.
After connected, user get the correct IP address. In router, sh crypto session, it has SA, etc. But sh ip route, can't find the Static route point back to the client IP like other connections.
At user end, windows show the IP address but no gateway. Windows route print shows the VPN network via gateway xxx.xxx.xxx.1 which is not available.
HIDoes anyone know if there is an easier way than the belowQ. I check connection events for IOC's when requested and sometimes i have to check many url's which i am presently doing one url at a time and is very time consuming, is there a way to check mult...
Cisco Identity Services Engine (ISE) gives you intelligent Integrated protection through intent-based policy and compliance solution. ISE supports external MDM vendor integration to help the customers to look for compliance of a dev...
This video provides the steps to configure the Cisco Threat Response (CTR) and ESA Integration.
This is live on the portal:https://video.cisco.com/video/6159336218001
And on YouTube:https://www.youtube.com/watch?v=UCKIdx5rdFg
I need to migrate from C170 to C190 and have already match to the same Firmware Version. I have a question. Is there any method that can export and import the configuration file instead of form cluster ?