VPN Client 3.6 to PIX, tunnel comes up but...............

[tvorhauer]

I am trying to configure a PIX to terminate a VPN tunnel from a remote PC with VPN Client 3.6. I am able to get the tunnel up, but cannot ping anything on the internal network. Any suggestions would be appreciated.

Thanks!

[Karthik.Krishnamurthy]

Did you check the routing for the IP pool that you used ?? if not check the routing for the IP pool and point the route to the firewall . Also check the access-lists .

[tvorhauer]

Not exactly sure what you mean. The remote client is receiving an IP address from the pool.

Thanks.