05-10-2013 04:54 PM
Hi all, I have a CIsco ASA 5512-X (8.6(1)2). I configured VPN Client access for some users, the can access to the internal network resources without problems, but two client VPN cannot reach each other.
I have configured the the static NAT without possitive results.
same-security-traffic permit inter-interface
same-security-traffic permit intra-interface
object network network-local
subnet 10.0.30.0 255.255.255.0
object network VPN-Client
subnet 192.168.254.0 255.255.255.0
nat (inside,outside) source static any any destination static VPN-Client VPN-Client
I guess I'm missing something in the ASA config.
I'd appreciate your comments.
Thanks a lot.
David
Solved! Go to Solution.
05-10-2013 05:09 PM
David,
Are you using split tunnel?
Incase you are make sure that you have vpn pool subnet 192.168.254.0 255.255.255.0 part of split tunnel.
same-security-traffic permit intra-interface is all required to make the U turning work.
Regards,
Varinder
P.S. Please mark this post as 'Answered' if you find the above information helpful so that it brings goodness to other community users
05-10-2013 05:09 PM
David,
Are you using split tunnel?
Incase you are make sure that you have vpn pool subnet 192.168.254.0 255.255.255.0 part of split tunnel.
same-security-traffic permit intra-interface is all required to make the U turning work.
Regards,
Varinder
P.S. Please mark this post as 'Answered' if you find the above information helpful so that it brings goodness to other community users
05-10-2013 05:37 PM
Thanks a lot Varinder.
The split tunnel was the problem.
Thanks again
David
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide