VPN Conncection between 3030 and Client freeze

[t.braun]

We have sometimes the problem that a good working connection after a periode of time (for example 2 houres) freeze. The connection was not terminated but you are no more able to work on this connection.(No or only some data pass the Tunnel) Not even a ping to an internal maschine is possible. When you discconect, you are immediate able to connect again and continue work. Did anyone have the same problem or an idea what goes wrong here ?

On two of four such connections I find the following in the log :

"IKE AM FSM error history (P1 struct &0x7379570):

[20, 65535], [9, 78], [9, 32], [9, 65535]"

and

"Header invalid, missing SA payload! (next payload = 8)"

Is there a causal connection to our problem ?

Thanks for answer !

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

[tmartin25]

Having the same issue here. Using latest clients on both sides. I have also noticed that if you wait long enough that it sometimes comes back.

I have also noticed that pulling a lot of data at once can instigate this activity.

What I've seen has actually happened as early as 5-15 minutes as well.

Sorry I can't be of some help but I'm defintely feeling your pain.