06-14-2014 06:01 PM
Hi
I need some help related to GRE Point to Point & MGRE, Dynamic routing issue
P2P GRE
I have configure P2P GRE , i am able to ping from R1 to R3 & R3 to R1 Tunnel IP, but after enabling IGP dynamic protocol i am not able to ping and the Tunnel is getting down, Any Idea,
here the configuration of GNS using 3725 with IOS 12.4
R1
int fa0/0
ip add 10.1.101.1 255.255.255.0
no sh
int loo 0
ip add 1.1.1.1 255.255.255.255
int tun 1
ip add 192.168.1.1 255.255.255.0
tunnel source 10.1.101.1
tunnel destination 20.2.102.3
ip route 0.0.0.0 0.0.0.0 10.1.101.2
R2-ISP Router
int fa0/0
ip add 10.1.101.2 255.255.255.0
no sh
int fa0/1
ip add 20.2.102.2 255.255.255.0
no shut
R3
int fa0/0
ip add 20.2.102.2 255.255.255.0
no sh
int loo 0
ip add 3.3.3.3 255.255.255.255
int tun 1
ip add 192.168.1.3 255.255.255.0
tunnel source 20.2.102.2
tunnel destination 10.1.101.1
ip route 0.0.0.0 0.0.0.0 20.2.102.2
06-17-2014 03:39 AM
Hi Shakeel,
You haven't posted anything about the IGP configs which you have put on the routers.
Regards
Karthik
06-17-2014 10:50 AM
Hi karthik
here the IGP configuration
R1
router eigrp 100
No auto
net 10.0.0.0
net 1.0.0.0
net 192.168.1.0
R3
router eigrp 100
No auto
net 10.0.0.0
net 1.0.0.0
net 192.168.1.0
06-18-2014 12:34 AM
You should configure 'passive interface ' on both tunnel interfaces. it can avoid establishing adjancy between tunnel end points.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide