cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
517
Views
5
Helpful
1
Replies

VPN user can't access server

jm.virtual01
Level 1
Level 1

My VPN users can't access the one server. Server is in outside network.

My server 1 IP: 10.210.12.12

My server 2 IP: 10.230.15.16

My VPN network: 10.30.25.0/24

My inside Network: 10.30.26.0/24

The inside user can access the server 1 and server 2 but the VPN users are not able to access the server 1. The VPN user can access server 2.

The routing table on firewall is as below,

route Outside1 0.0.0.0 0.0.0.0 12.32.80.81 1
route Inside 10.210.0.0 255.255.0.0 192.168.21.10 1
route Inside 10.230.0.0 255.255.0.0 192.168.21.10 1

route Inside 10.205.0.0 255.255.0.0 192.168.21.10 1
route Inside 10.209.0.0 255.255.128.0 192.168.21.10 1

route Inside 10.33.25.0 255.255.255.0 192.168.21.10 1

route Inside 10.33.26.0 255.255.255.0 192.168.21.10 1

route Inside 10.33.28.0 255.255.255.0 192.168.21.10 1

 

in this routing table 192.168.21.10 is my core device and it is configured properly, i believe.

Soneone has any suggestion ? 

There is one more router after Firewall but i am not sure about it's configuration, i believe it is good and i don't have access for that router.

1 Accepted Solution

Accepted Solutions

Francesco Molino
VIP Alumni
VIP Alumni
Hi

If your 2 servers are on the outside zone, why the routing is saying route inside?
You said your internal users are able to access those servers but based on asa routing the traffic never goes to outside zone.
Can you share the config of your core switch as well please?
Also can you share the config of your asa to see acls and nat?

Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question

View solution in original post

1 Reply 1

Francesco Molino
VIP Alumni
VIP Alumni
Hi

If your 2 servers are on the outside zone, why the routing is saying route inside?
You said your internal users are able to access those servers but based on asa routing the traffic never goes to outside zone.
Can you share the config of your core switch as well please?
Also can you share the config of your asa to see acls and nat?

Thanks
Francesco
PS: Please don't forget to rate and select as validated answer if this answered your question
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: