cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
7405
Views
5
Helpful
4
Replies
ohforce55
Beginner

Wireshark and Anyconnect

I'm using Windows 10 and recently tried capture packets but there was no any capture interface came up after installing Wireshark.

 

I noticed that I had to use Win10Pcap intead of WinpCap 4 something and I finally could see the capture interfaces.

 

But when I connected to the Cisco VPN (Anyconnect), I still can't see the capture interface for the anyconnect...

 

Please advise me..

 

Thank you!

4 REPLIES 4
GioGonza
Enthusiast

Hello @ohforce55,

For newer versions of wireshark it doesn´t work when you try to verify the interfaces to capture traffic, you need to open the Wireshark Legacy that should be also installed and with this one, you are going to be able to see the interface and check the capture for AC.

Have a good one!

Gio

Thank you for your reply!

I will check!

Mohammad Alhyari
Cisco Employee

Thank you!

I will try to install it.

Create
Recognize Your Peers
Content for Community-Ad