Can an Ironport work in both WCCPv2 and L4 Traffic monitoring modes at the same time?

[jfgobin01]

Hello Ciscoers,

We have an ironport installed and we use WCCPv2 to redirect the traffic. And as it occurs, I have a need to forward the traffic for another network, that uses another path to the Internet.

So I was thinking using the L4 Traffic Monitoring.

To the best of your knowledge, is there a way to have the appliance use both WCCPv2 and L4 Traffic monitoring at the same time? From the configuration, it's one or the other.

Thanks,

J.

[yao yu jiang]

yes, but my problem is I can see the l4tm report and logs, but I did not receive the tcp-reset, the session is never tear down, I use the switch span port

[jfgobin01]

Ok. I'll try.

As a matter of fact, I plan to use policy-based routing to forward all the "interesting" traffic to the appliance.

For your TCP-Resets not seen, do you allow ingress on the span session?

J.

[yao yu jiang]

yes, I have span destination port ingress set,

I can see the icmp unreachable packet, but not tcp reset packet.