12-20-2019 07:09 PM
Hi all - I just bought a used s170 on eBay and I cannot connect per the startup guide. Assuming it’s because the previous owner didn’t reset the configurations.
how would you recommend I get in? Nmap when connect to attempt to identify the IP address? Any other tips?
12-20-2019 10:32 PM
12-21-2019 02:09 AM
here is the reset to default - (this will erase all config and license also). and make it default.
here is a quick start
https://www.cisco.com/c/dam/en/us/td/docs/security/wsa/hw/S170_QSG_78_19643.pdf
12-29-2019 06:33 AM
Hello Joshua,
you need TAC to reset the password to login before you can do "resetconfig". even if you get serial/console access , to run the command you will need to login and since you don't have the IP address, I am assuming you wouldn't have the password as well.
Regards
Shikha Grover
PS: Please don't forget to rate and select as validated answer if this answered your question
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: