cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
694
Views
0
Helpful
1
Replies

Webex Call Local PSTN Gateway Dial peer Configuration

Brandon Rebbe
Beginner
Beginner

I have an ISR4321 with Cube licenses and i already have it registered to my Webex Calling Location and online. 
The examples for Dial peers in the deployment guide refence sending the calls via IP to another service or gateway from the ISR Cube.  
Our setup is an ISR with a local T1 card in it that will replace our existing 2901 that it MGCP to CUCM. 

 

My question is: Can i have the calls routed to the local T1/PRI port or do i have to keep my old 2901 setup and the Cube just forwards the Calls to it? The example shows IP PSTN and i need to adjust the dial peers to use the local Interface i think. 

 

2020-12-08_21-25-31.png

 

1 Accepted Solution

Brandon Rebbe
Beginner
Beginner

I think i found the solution on the Cisco Japanese Support Community. This document shows the Dial peer statements needed for the local gateway to have a PRI instead of forwarding it on to another IP ISP.  

https://community.cisco.com/t5/%E3%82%B3%E3%83%A9%E3%83%9C%E3%83%AC%E3%83%BC%E3%82%B7%E3%83%A7%E3%83%B3-%E3%83%89%E3%82%AD%E3%83%A5%E3%83%A1%E3%83%B3%E3%83%88/webex-calling-%E3%83%AD%E3%83%BC%E3%82%AB%E3%83%AB%E3%82%B2%E3%83%BC%E3%83%88%E3%82%A6%E3%8... 

View solution in original post

1 Reply 1

Brandon Rebbe
Beginner
Beginner

I think i found the solution on the Cisco Japanese Support Community. This document shows the Dial peer statements needed for the local gateway to have a PRI instead of forwarding it on to another IP ISP.  

https://community.cisco.com/t5/%E3%82%B3%E3%83%A9%E3%83%9C%E3%83%AC%E3%83%BC%E3%82%B7%E3%83%A7%E3%83%B3-%E3%83%89%E3%82%AD%E3%83%A5%E3%83%A1%E3%83%B3%E3%83%88/webex-calling-%E3%83%AD%E3%83%BC%E3%82%AB%E3%83%AB%E3%82%B2%E3%83%BC%E3%83%88%E3%82%A6%E3%8... 

Getting Started

Welcome to the Webex Community. This is your home to ask questions, share knowledge, and attend live webinars.

Recognize Your Peers