10-21-2011 05:03 AM - edited 07-03-2021 08:58 PM
Hi All,
Just have a basic querry, What is the default mode of 1142 AP. When it's shipped from Cisco, Does it works as LAP or it can be used as a Autonomous ?
Also, incase we just get it shipped from Cisco, does it have any default IP address that we can use to telnet it from the PC.
Pls. suggest. Thanks !
Regards
Harish
10-21-2011 05:07 AM
The default mode as per your quote to Cisco, you can ask for CAPWAP or IOS image.CAPWAP mode AP will have default IP of 10.0.0.1, if you haven't configured DHCP.
Thanks
NikhiL
10-21-2011 05:12 AM
Hi NIkhil,
That's right that after getting the console we can come to know via ios image version. But what the default status, when Shipped from Cisco ?
Thanks !
10-21-2011 05:13 AM
AIR-LAP1142N-A-K9 = CAPWAP part number
AIR-AP1142N-A-K9 = Autonomous part number
Same AP just different code and you can swap code if needed.
10-21-2011 05:19 AM
Oh Yes.. That's very basic thing I always ignored to see.
Thanks alot for bringing it to my notice.
10-21-2011 05:25 AM
If you find any of these post helpful please support the rating system ...
10-26-2011 09:24 AM
Hi George,
today I get my first AIR-LAP1042N-E-K9. I didn't know about the LAP - AP differences.
But may be it's possible to swap mode to autonomous?
Regards
Daniel
10-26-2011 09:31 AM
Yes, you can convert the Lap to autonomous mode. Check cisco.com for process.
Regards
Harish Chopra
Sent from my iPhone
10-26-2011 09:33 AM
Yes, of course.
here is the doc:
https://supportforums.cisco.com/docs/DOC-15126
If you find this helpful please support the rating system
thanks
10-26-2011 09:57 AM
Wow.... what a fast answer. Thanks.
But I'm not able to download the file c1140-k9w7-tar.124-25d.JA1.tar, because I have no service contract :-(
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: