12-11-2010 11:50 AM - edited 07-03-2021 07:32 PM
I'm new to Cisco dot11radio configurations.
Can someone please share the commands I would use to set the 2.4 and 5Ghz radios so that older laptops can see their SSID broadcasts and connect.
Thanks in advance.
Solved! Go to Solution.
12-12-2010 06:45 PM
configure these command and see if there is any improvement..
en
conf t
int dot11 0
preamble-short
no dot11 extension aironet
end
Lemme know if this helps..
Regards
Surendra
12-12-2010 07:02 PM
Bingo! Thanks!!
12-12-2010 07:07 PM
worked??
Lemme know if that answered your question
Regards
Surendra
12-12-2010 07:18 PM
surbg wrote:
configure these command and see if there is any improvement..
en
conf t
int dot11 0
preamble-short
no dot11 extension aironet
end
Lemme know if this helps..
Regards
Surendra
Yes--that worked!
Thanks very much for your help tonight.
12-12-2010 07:20 PM
Thats nice to hear!! and its my pleasure assisting you!
Good night!!
Regards
Surendra
12-12-2010 07:33 PM
Thanks for hanging in there with me on this! Good job!!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: