12-21-2010 02:10 AM - edited 07-03-2021 07:34 PM
Hi Everyone,
I am setting up pair of 1242 APs as Root and Non-Root bridge, i am not able to find the Install Mode on the 1242 AP while setting the Non Root for Best signal.
any help will be appreciated.
HM
Solved! Go to Solution.
12-21-2010 02:13 AM
Hi HM,
AFAIK, we do not have the INSATALL mode on the 1242 AP if we are using it as ROOT and NONROOT.. this is available only on 1310 bridge or 1410 bridges.. not on 1242AP..
lemme know if this answered your question..
Regards
Surendra
====
Please dont forget to rate the posts which answered your question and mark it as answered or was helpfull
12-21-2010 02:13 AM
Hi HM,
AFAIK, we do not have the INSATALL mode on the 1242 AP if we are using it as ROOT and NONROOT.. this is available only on 1310 bridge or 1410 bridges.. not on 1242AP..
lemme know if this answered your question..
Regards
Surendra
====
Please dont forget to rate the posts which answered your question and mark it as answered or was helpfull
12-21-2010 02:20 AM
As i guessed and this comunity is very quick compared to apple.
very much impressed.. Thanks again..
HM
12-21-2010 02:22 AM
ha ha Thank u..
Regards
Surendra
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: