Is there a duration or procedure of power cycling and pressing the reset button on the front panel of the 2504 that ensures complete factory reset? I've been trying to do a reset (holding in after power up for about 10 seconds until ALM LED illuminates) but I don't know that is doing a full reset.
I've connected to port 2 with a cat5 cable connected directly to the NIC on a laptop. I never get a DHCP address issued so I tried setting a fixed IP address to 192.168.1.100 / 255.255.255.0 GW 192.168.1.1. On both units I don't get any responses to an http://192.168.1.1 in Firefox or IE. No responses to ping either. I tried the other physical ports on the 2504 but no difference. Both 2504 units behave the same way. Any recommendations to make a connection to the web GUI?
I ordered a NULL modem adapter to try as my normal serial port cable gets no response on the console connection using the console cable. Maybe that will let me in?
QuestionI have the following Air AP:Air-AP1562I-B-K9, 802.11ac outdoor access point There are three antenna cables that go from the inside cover to some soldered connections on a PCB. When removing the cover, two of the soldered antenna connections c...
QuestionHiWe have a guest access set up and was wondering what exactly are the sequence of events from connecting to SSID to being granted internet access, see below steps I'm unsure of are left blank1. connect o SSID through AP2. traffic hits Foreign WLC...
Model:C9120AXI-Q Install EWC on C9120 running with CAPWAP as shown in the attached log, but the installation fails.It looks like you're getting an error like out of storage space.Is there any good way?