I got a 2802 Access Point where I installed the CME image 22.214.171.124 on.
I can add local mac addresses for mac filtering.
Is it also possible to use a Radius server e.g. freeradius for mac address authentication?
Yes, you can use mac filtering via Freeradius (see the freeradius wiki page).
You can’t perform dot.1x and MAB at a same time.
Please check the reply of mine on this thread for configuring external radius.
you have to enable the MaC filtering in SSID and need to enable and configure the external radius server IP with shared secret key.
So that whenever user tries to connect it will verify the mac address on external server. Then provide access accordingly.
But then I can't use WPA2-Personal with a PSK right?
My idea was to setup a WPA2-personal with a PSK and a mac filter with external radius.
Is that possible?
That is possible.
you can have a WPA2 Personal and Mac with external radius can be done. Configure a SSID with PSK and MaC filtering as usual only additional thing you have to do is configuration of Radius server. So that you can achieve the thing you want.
you can’t have WPA2 Enterprise and MAC with external radius is not possible.
Refer this thread . You can do this via CLI Commands.