cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

180
Views
0
Helpful
1
Replies

9800-40 initial setup

Hi All,

Need help for configuring 9800-40 standalone WLC. We have done bootup config for WLC. Also able to access through http. We defined dayzero config through GUI. Once we finish it , we got message configuration successfully applied then login page came. Once we put credential , it again ask dayzero config. 

Any specific reason for that

1 REPLY 1
Highlighted
VIP Mentor

Re: 9800-40 initial setup

I think you are not saving the config in NVRAM.

 

please follow the deployment guide:

 

https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/9800-40/installation-guide/b-wlc-ig-9800-40/power-up-and-initial-configuration.html

 

Regards

Dont forget to rate helpful posts

CreatePlease to create content
Content for Community-Ad

August's Community Spotlight Awards