I have a few questions about best practices for mesh network deployment:
I'm using WLC 3504 and 1560 APs.
- is it better 8.5 release or 8.8?
- on mesh bridge access-points:
-- what about channel width of backhaul link? 20-40 or 80MHz on RAP access-points?
-- with ethernet bridging enabled, which is the difference between vlan support on mesh tab and vlan support on gigabit ethernet port? which native vlan do I have to use on both tabs? Which vlan do i need to configure on rap's switch port? and which vlan on map's switch port? (i need to connect a switch on maps in order to carry wired vlan's over mesh network.
- on general mesh:
-- extended backhaul client access yes/no? what is this function for?
The Ap lose ip static, we thought the Ap was not able to communicate with the WLC with assigned static IP address. When this happens the ap will fall back ti trying ti get a DHCP address.This occur randomly in platform controller 2504 with AP's model AIR-...
Dear Friends, I have to upgrade IOS in 5520, here my question was how to identify which FUS was installed in the WLC.GUI ----Software Version 188.8.131.52Emergency Image Version 184.108.40.206 -------sh sysinfo Product Version....................
Security has become one of the greatest concerns for every company alike. The industry is moving towards a fast paced and customer-oriented network infrastructure which automatically increases the vulnerabilities a network is exposed to. As the industry t...
We got some new Apple Macbook Air, when connected to wifi, we found the link speed was only 54Mbits, but other laptops like DELL or Panasonic were working fine, the link speed was at least 800 Mbits. we are using Cisco WLC 5504 and 2702I ap.and the funny ...