Access point Air -AP 1242AG-E-K9

[ahmedmaged9432]

I have these access point i need to do reset for it to reconfigure again , how to to reset , i have tried to press mode button but still in the Putty it blink with nothing to display in the screen .

[patoberli]

You have to press the button for the correct amount of time, not too long, not too short.
Without checking the manuals, for the newer models it's about 25 seconds of pressing the mode button when powering it on.

But you should get an output when you just power them on in Putty. If you don't get anything, then either the speed is wrong, cable or some adapter is not correctly working.

[David Ritter]

um, you should be able to console into the AP and do a del flash:config.txt..  unless no uid/pw available.