Add new VLAN to Aironet 1400 Wireless Bridge

[deathngravity]

Having a hard time finding the correct documentation/answer to add another VLAN to an Aironet Wireless bridge.  I just inherited this setup & still coming up to speed.

Have 3 existing Cisco AIRBR 1410 & I need to add another VLAN to the bridge group.   

They are out of support & end of life.  Hopefully they can be replaced later this year, but need to live with them for now.

Below is a current config of one of the VLANs (VLAN 103).  Currently 6 are being trunked across the bridge

dot11 vlan-name v103 vlan 103

interface Dot11Radio0.103
encapsulation dot1Q 103
no ip route-cache
bridge-group 103
bridge-group 103 spanning-disabled

interface FastEthernet0.103
encapsulation dot1Q 103
no ip route-cache
bridge-group 103
bridge-group 103 spanning-disabled

I assume if I want to add a new VLAN20...  I would just copy the above config for the new VLAN?

dot11 vlan-name v20 vlan 20

interface Dot11Radio0.20
encapsulation dot1Q 20
no ip route-cache
bridge-group 20
bridge-group 20 spanning-disabled

interface FastEthernet0.20
encapsulation dot1Q 20
no ip route-cache
bridge-group 20
bridge-group 20 spanning-disabled

Thanks & I appreciate any help.

Cheers!

[Rafael E · Accepted solution]

this is a good document for multiple VLANs on a WGB or bridge AP

https://www.cisco.com/c/en/us/support/docs/wireless-mobility/service-set-identifier-ssid/211293-Configure-Work-Group-Bridge-WGB-Multip.html

[Rasika Nayanajith · Accepted solution]

Yes,  that config will achieve what you want.

Make sure clan 20 defined on your switches

Rasika

[deathngravity]

Thanks & I appreciate the help.

Cheers!