Aironet 1310 bridge does not reestablish connection
We have an aironet 1310 bridge installed (root/non root) where the non root drops sometimes the signal when the morning sun is in direct line with the link. This blackout problem is known. What bothers me is the fact that the bridge does not automatically reestablish the association...
Once it has been lost we have to restart the Air 1310, then it re-associates. Is there a workaround or an automatism?
Re: Aironet 1310 bridge does not reestablish connection
This should be automatic. I had a client have this problem once, and we found that the problem was actually with the 1310 being configured in diversity mode. The 1310 would disconnect in tough weather conditions and try to connect to the little metal stub that comes on the bridge. The signal was too weak to establish a good connection, but for some reason it would not switch back.
So check to see if you have diversity mode enable, and disable it if it is. If that's not the problem, I'm not sure what it could be. Have you tried upgrading the IOS?
After adding a WLC to ISE if you get the following error (See message below) after running debug aaa tacacs enable in the WLC. Incorrectly formatted authorization message Here's what you need to do to fix it. Login to ISE Work centers, Settings, Device ad...
Community Live- Understanding How Multicast Works with Cisco Wireless LAN Controllers
(Live event - formerly known as Webcast- Tuesday November 19, 2019 at 9 am Pacific/ 12 pm Eastern / 6 pm Paris)
This event will have place on Tuesday 19th, Novembe...
Where to download
Attached files on this post
Alternatively, cloud version (only summaries)
New implementation for the WLC Config Analyzer. it is a new re-write of the application, with clean up and improved checks
Support for IOS...
New Version for the Wireless Lan Config Analyzer: v.4.4.14
Supports AireOS up to 8.8, any model.
Error parsing AP list with location with spaces
For tool information: