cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
801
Views
0
Helpful
2
Replies

Aironet 1602e on 2504 Controller

INSYSGROUP
Level 1
Level 1

I was wondering if there was a way to include additional AP configuration information on the controller.  I'm trying to program the following on some Aironet 1602s:

1.  Program the timezone to Eastern

2.  Program daylight savings to EDT (recurring)

3.  Program the correct antenna DBi information

I know this is a bit trivial, but I'm a little picky.  I can program this info, but every time an access point is restarted, the info is lost.

Mike R.

2 Replies 2

Leo Laohoo
Hall of Fame
Hall of Fame

1.  Program the timezone to Eastern

2.  Program daylight savings to EDT (recurring)

Once you configure the Country and the timezone, DST would be automatic.

3.  Program the correct antenna DBi information

Go to Wireless > Access Points > Radio > right-hand of the AP and choose "Configure" > go to "Antenna Parameters" and enter the value under "Antenna Gains".

If your antenna is, for example, 4 dBi then the value entered is "8".

I forgot to mention, the controller is running 7.4.0.60 firmware.  I tried looking into the wireless settings, but I didn't see it.

The antenna DBi is entered for both radios (2.4/5 GHz).  I know you can set it in the CLI, but I couldn't find it on the 2504 controller.  Any chance you can throw a couple of screen shots?

Thanks.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: