Aironet AP default password

[Nusret Conk]

What is the default password for AP1702i access point?

[aleopoldie]

Did you try Cisco/Cisco as username/password ?

-AL

[Nusret Conk]

Al,

That didn't work. Any idea what it takes to reset it to the factory defaults?

[aleopoldie]

It should be Cisco.

Are you sure it is a factory AP ?

AL

[Nusret Conk]

our customer bought a few months ago a couple of these. Not sure if they configured previously or not but today they want to give them a try.

Not sure if I answered your question of "factory AP"...

[aleopoldie · Accepted solution]

Alright, then just reset them to factory config and they will have the default password "Cisco"

Hope this helps,

-AL

[Sam Smiley · Accepted solution]

Nusret,

This should get you back to the defaults:

https://popravak.wordpress.com/2014/08/26/resetting-cisco-capwaplwap-access-point-to-factory-defaults/

Regards,
Sam

[Nusret Conk]

Thank you Sam and AL

[Alex Pfeil]

I had converted an LWAPP to an autonomous AP.  I was then able to telnet into the AP.  I thought the username and password would stay the same, but it resets to the default. I was glad to come across this info.  The telnet username and password was Cisco after the conversion. Thanks!