Aironet AP1852 infinite Discovery Request Loop After SW Upgrade (8.6.101 to 8.10.130)
We recently purchased a Aironet AP1852I-E-K9 unit to use as a stand-alone WAP extension for an existing wired network. All it had to do was add wireless tablets to our existing wired network. There are no other wireless devices, no wireless controllers. The system worked fine, except that it kept on booting the user out of the wireless controller management interface (10.0.0.10) after a few seconds, and no settings could be changed.
We performed a TFTP SWupdate on the device (from 8.6.101 to 8.10.130), after which the management info shows that no APs are suddenly visible. Upon viewing the config dump for the old SW version compared to the new version, the following line is missing:
config flexconnect group default-flexgroup ap add 68:ca:e4:40:46:68
Upon manually trying to add the command via CLI, the "ap add" is no longer available. Also, no success on creating any new flexgroups. The MAC address shown above is assigned 192.168.20.X by the DHCP server.
Logging in to the APCISCOSHELL, the AP repeatedly sends Discovery request sent to Flex.. (10.0.0.1). After a certain time elapsed the feedback shows that the DHCP has been "CAPWAPd" and a new address on the 192.168.20.x subnet is assigned.
The LEDs keep showing the Discovery/Join process is active. Can anyone please assist in helping to get the AP1852 to see its own internal access point/controller?
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 188.8.131.52, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...
Hey Guys,I Have several 1600 Series AP's (AIR-CAP1602I-ZK9) that was working with WLC before, I changed them with 1800 series but would like to use 1600 Access Points series independently and without WLC for somewhere else, so I want to know do they...