07-30-2012 02:23 PM - edited 07-03-2021 10:28 PM
Hi,
I am all new to this. I have a stand alone 1140 AP and i am trying to perform a site survey using the AP; However I dont know what configs need to be on the AP for the survey ? can you help me please?
07-30-2012 02:33 PM
all you need is a very basic config. Just be sure to set the power to half what the client can support.
dot11 ssid Survey
authentication open
authentication key-management wpa version 2
wpa-psk ascii 0 Survey1234
!!
!
!
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption mode ciphers aes-ccm
!
ssid Survey
HTH,
Steve
-----------------------------------------
Please remember to rate useful posts, and mark questions as answered
07-30-2012 02:49 PM
Thank you for your quick answer.
Both Radios need to be on? Radio0 and Radion1 which one is the 2.4 and 5 ghz?
07-30-2012 03:03 PM
It depends. If you are only looking for 2.4GHz, then no. But if you want 5GHz coverage as well, then yes.
Radio0 is the 2.4
Radio1 is the 5
HTH,
Steve
-----------------------------------------
Please remember to rate useful posts, and mark questions as answered
07-30-2012 03:09 PM
This What I have on the AP right now.
the ssid "Survey" needs to be brodcasted for the Survey? if so how can i set ip up on th eAP?
!
no aaa new-model
!
!
dot11 syslog
!
dot11 ssid Survey
authentication open
authentication key-management wpa version 2
!
!
!
username Cisco password 7 05280F1C2243
!
!
bridge irb
!
!
interface Dot11Radio0
no ip address
no ip route-cache
!
encryption mode ciphers aes-ccm
!
ssid Survey
!
antenna gain 0
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface Dot11Radio1
no ip address
no ip route-cache
!
encryption mode ciphers aes-ccm
!
ssid Survey
!
antenna gain 0
dfs band 3 block
channel dfs
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
!
interface GigabitEthernet0
no ip address
no ip route-cache
duplex auto
speed auto
no keepalive
bridge-group 1
no bridge-group 1 source-learning
bridge-group 1 spanning-disabled
!
interface BVI1
ip address dhcp client-id GigabitEthernet0
no ip route-cache
!
ip http server
no ip http secure-server
ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
bridge 1 route ip
!
!
!
line con 0
line vty 0 4
login local
!
end
07-30-2012 03:23 PM
under the SSID add the command guest-mode. that will broadcast the SSID. Don't forget to add in your wpa key as well
HTH,
Steve
-----------------------------------------
Please remember to rate useful posts, and mark questions as answered
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: