cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Community Live- Understanding How Multicast Works with Cisco
1722
Views
0
Helpful
7
Replies

AP 1142N low power

hi

i connected a new Cisco 1142n access points to a cisco 3560E 24 port POE switch. the AP is getting only lower power which is 14.5 but the switch is capable of deleivering 15.4 watts. i checked the console messages in the AP and it is giving the error message 

CDP_PD-2-POWER_LOW: All radios disabled

there is an other same model AP connected to the switch and it is getting full power

please let me know asap because i am in middle of a project

Thanks

Karthik

Everyone's tags (1)
7 REPLIES 7

AP 1142N low power

In the AP config, you can go in and tell it that it's getting pre-standard power.  Optionally, you can disable CDP on that port as well.

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered

AP 1142N low power

are you asking me to login to AP and set a prestandard power

please explain me how to do it

AP 1142N low power

for an IOS AP,

conf t

config power inline negotiation prestandard source

If this is a WLC installation, it's in the AP config

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered

AP 1142N low power

but in the switch if i type in the command show power inline i see this AP drawing only 14.5 watts..there is another AP connected to this switch which is drawing enough power 15.4 watts

Re: AP 1142N low power

that can happen. Depends in how much power the switch tells the AP is available during the CDP/FLP negotiation

Sent from Cisco Technical Support iPhone App

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
Highlighted

AP 1142N low power

hi

can you let me know how to make the controller upgrade the image of a new Cisco AP connected.

Hall of Fame Community Legend

AP 1142N low power

On the Cisco switch, please post the output to the command "sh power inline".

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards