cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
500
Views
0
Helpful
6
Replies
Highlighted
Beginner

AP 1524 Bridge configuration

Hi all,

Someone already do a bridge configuration with 1524 AP? I read Cisco documentation, and is not very clear regarding configuration on switch side.

I will do a Bridge in trunking mode, so i want to know what is the VLAN i need to set as native vlan on the switch trunk port.

Do i need to set the management vlan as native VLAN? Is someone had some documentation regarding this, please send me information.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

Most of the time if the AP or Mesh ap is not in h-reap/flexconnect, then you configure it as a switchport access.

-Scott
*** Please rate helpful posts ***

View solution in original post

6 REPLIES 6
Highlighted
Hall of Fame Master

The ap management vlan should be the native vlan you configure on the switch if your are trunking.  Also aloow only the managment vlan and any other vlans that you will be placing wireless users on.

-Scott
*** Please rate helpful posts ***
Highlighted

Most of the time if the AP or Mesh ap is not in h-reap/flexconnect, then you configure it as a switchport access.

-Scott
*** Please rate helpful posts ***

View solution in original post

Highlighted

Nice thanks.

Did i need to do this on both RAP and MAP switch port configure as trunk? (Native vlan management)

Thanks

Highlighted

The RAP is the only one that is connected to an ethernet port, so I would just use an access port.  The MAP connects to the RAP, so there is no ethernet configuration.

-Scott
*** Please rate helpful posts ***
Highlighted

Thanks, but in my case i want to configure a point to point bridge configuration.

The point is , i want to use and give the same layer 2 vlan on a switch on the MAP side.

Did is possible? I have some device on the MAP side directly connect on a switch and the layer 3 switch is on the RAP side.

Thanks

Highlighted

Thierry,

Here is a link... just scroll down to Ethernet VLAN Tagging Guidelines

http://www.cisco.com/en/US/docs/wireless/controller/7.0/configuration/guide/c70mesh.html#wp1542630

-Scott
*** Please rate helpful posts ***
Content for Community-Ad